[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Cutting Oil Life Extension



Title: Message
Onsite recycling of cutting fluid aside and pending machining requirements, cutting fluid use has been minimized by using spray/misting-type technologies and also by replacing the fluids with air-cooling.
Compressed air was used for cooling the part in the observed instance but since the process pressure was well below 30psi it indicated a blower could perform the same function without the energy penalty involved using compressed air.
 
Ric   
 
-----Original Message-----
From: owner-p2tech@great-lakes.net [mailto:owner-p2tech@great-lakes.net] On Behalf Of Gary Hunt
Sent: Monday, March 16, 2009 9:03 AM
To: Vinson, Thomas; p2tech@great-lakes.net
Subject: RE: Cutting Oil Life Extension

Thomas,

It depends on the type of cutting fluid that is being used, the quantities involved and the machining requirements. There are a number of well proven ways that   synthetic cutting fluids can be recycled and a lot of info available. Check out http://wrrc.p2pays.org/industry/indsectinfo.asp?INDSECT=45 . References are a little dated, but the basics have not changed. Good luck.

 

Gary Hunt

Director

Division of Pollution Prevention and Environmental Assistance North Carolina Department of Environment and Natural Resources

1639 Mail Service Center

Raleigh, NC 27699-1639

Phone: 919-715-6508

Fax: 919-715-6794

E-mail: gary.hunt@ncmail.net

Web page: www.p2pays.org

 

Mail correspondence to and from this address may be subject to the North Carolina Public Records Law and may be disclosed to third parties.

 

From: owner-p2tech@great-lakes.net [mailto:owner-p2tech@great-lakes.net] On Behalf Of Vinson, Thomas
Sent: Monday, March 16, 2009 1:15 AM
To: p2tech@great-lakes.net
Subject: Cutting Oil Life Extension

 

Greetings from Busan Korea.  Jeff and I are in a meeting and we are being asked about alternatives to extend the life of cutting oil.  Does anyone have an option for reuse of cutting oil, or any specific options for this company?